Concealed Cistern Installation Guide

For Visam products we have explained clearly the installation Operation in 2 parts. Before Mortaring Process for Installation of Concealed Cistern

Drill, Saw, Water Gauge, Tape Measure, Spanner ( 19 – 22 ), Hammer, Screwdriver
First Step

• Remove the lower part of Soil Pipe Clamp by bending it to both sides.
• Fix the Soil Pipe to the Clamp.
• Measure the mounting hole of the Wall Hung WcPans. This length is usually 18 cm.
• First adjust the bolt nuts behind the console according to the measurements of the WC pan and then screw the rods to these bolt nuts.

• Open Side Lobes of the Supporting Console
• Measure the length between the Mounting Hole of WC Pans and Bottom of WC Pans. ( Consider the Filling and Tile height ).
• From the ground to the Rod , length should be 32–33cm.
• Tighten Nuts with the Spanner when you fix the height carefully.

• Place the Concealed Cistern to the point of settling in order to adjust the height of the Soil Pipe.
• Mark it carefully then cut the pipe to suitable height.
• Control the straightness of the Concealed Cistern with Water Gauge while fixing the Carrier Legs.
• Mark the points that will be drilled.
• Side lobes, Inner Lobes, Carrier Legs.
• Drill the marked areas using 10mm drill bit.
• Fix the Rawl Plugs (pegs) into the holes.
• Carefully place the Concealed Cistern then insert the screws.
• Tighten the screws with screw driver and spanner.
• Control the straightness of the Concealed Cistern with Water Gauge again before tightening the nuts.

• Remove the Plug at the top of the Cistern and open the Window in front of the Cistern.
• Fix the BranchTap to the Plumbing Pipe.
• Use the Sponge to prevent inclusions to the Concealed Cistern.
• Fix and tighten the Branch Hose to the Tap and control the system.
• Then plug the protector box and Concealed Cistern Window.

• Place theWindow Cover.
• Place the protective plastic to the Rods and also place the Stoppers to the Elbow Pipe and Soil Pipe. Do not remove these protectors until the end of Mortar Process.

Concealed Cistern Installation Process After Mortar

• Remove the Protectors.
• Measure the Elbow Pipe and Soil Pipe then cut them to proper height.
• Cut the Rods to proper height.
• Place the Wc Pans and tighten the nuts.

• Set theToilet Seat.
• Remove the Concealed Cistern Window Protector.
• Screw the Button Adjustment Piece.
• Fix the Concealed Cistern Flush Plate’s Frame to the Window.
• Set the Button Adjustment Piece into the Concealed Cistern Flush Plate then plug the Flush Plate.
• Installation Finished. Beneath these tiles, is a product only 8cm thin and a brand, trusted for 50 years.